User manual

84
Route setting information
Route search specications
Your navigation system sets a route to your destination by apply-
ing certain built-in rules to the map data. This section provides
some useful information about how a route is set.
CAUTION
When a route is calculated, the route and voice guidance
for the route are automatically set. Also, for day or time
traffic regulations, only information about traffic regulations
applicable at the time when the route was calculated is
considered. One-way streets and street closures may not
be taken into consideration. For example, if a street is open
during the morning only, but you arrive later, it would be
against the traffic regulations so you cannot drive along the
set route. When driving, please follow the actual traffic signs.
Also, the system may not know some traffic regulations.

The calculated route is one example of the route to your
destination decided by the navigation system while taking
the type of streets or traffic regulations into account. It is not
necessarily an optimum route. (In some cases, you may not
be able to set the streets you want to take. If you need to take
a certain street, set a waypoint on that street.)

If the destination is too far, there may be instances where the
route cannot be set. (If you want to set a long-distance route
going across several areas, set waypoints along the way.)

During voice guidance, turns and intersections from the
freeway are announced. However, if you pass intersections,
turns, and other guidance points in rapid succession, some
may delay or not be announced.

It is possible that guidance may direct you off a freeway and
then back on again.

In some cases, the route may require you to travel in the
opposite direction to your current heading. In such cases,
you are instructed to turn around, so please turn around
safely by following the actual traffic rules.

In some cases, a route may begin on the opposite side of
a railway or river from your actual current location. If this
happens, drive towards your destination for a while, and try
route calculation again.

When there is a traffic congestion ahead, a detour route may
not be suggested if driving through the traffic congestion
would still be better than taking the detour.

There may be instances when the starting point, the way-
point and the destination point are not on the highlighted
route.
 The number of traffic circle exits displayed on the screen
may differ from the actual number of roads.
Route highlighting
 Once set, the route is highlighted in bright color on the map.
 The immediate vicinity of your starting point and destination
may not be highlighted, and neither will areas with particu-
larly complex road layouts. Consequently, the route may
appear to be cut off on the display, but voice guidance will
continue.
Auto reroute function
 If you deviate from the set route, the system will re-calculate
the route from that point so that you remain on track to the
destination.

This function may not work under certain conditions.
Handling and care of discs
Some basic precautions are necessary when handling your
discs.
Built-in drive and care
 Use only conventional, fully circular discs. Do not use
shaped discs.

Do not use cracked, chipped, warped, or otherwise damaged
discs as they may damage the built-in drive.

Use 12-cm discs. Do not use 8-cm discs or an adapter for
8-cm discs.

When using discs that can be printed on label surfaces,
check the instructions and the warnings of the discs.
Depending on the discs, inserting and ejecting may not be
possible. Using such discs may result in damage to this
equipment.

Do not attach labels, write on or apply chemicals to the
surface of the discs.

Do not attach commercially available labels or other materi-
als to the discs.

To clean a disc, wipe it with a soft cloth, moving outward
from the center.

Condensation may temporarily impair the built-in drive’s
performance.

Playback of discs may not be possible because of disc
characteristics, disc format, recorded application, playback
environment, storage conditions and so on.

Road shocks may interrupt disc playback.
 Read the precautions for discs before using them.
Ambient conditions for playing a disc
 At extremely high temperatures, a temperature cutout
protects this product by switching it off automatically.

Despite our careful design of the product, small scratches
that do not affect actual operation may appear on the disc
surface as a result of mechanical wear, ambient conditions
for use or handling of the disc. This is not a sign of the
malfunction of this product. Consider it to be normal wear
and tear.
Playable discs
DVD-Video
p is a trademark of DVD Format/Logo Licensing
Corporation.

It is not possible to play DVD-Audio discs. This DVD drive
may not be able to play all discs bearing the marks shown
above.
CD
AVCHD recorded discs
This unit is not compatible with discs recorded in AVCHD
(Advanced Video Codec High Definition) format. Do not insert
AVCHD discs. If inserted, the disc may not be ejected.
< CRB4817-A >
Appendix