User manual

4
Notes on internal memory
Before removing the vehicle battery
If the battery is disconnected or discharged, the memory will be
erased and must be reprogrammed.

Some of the settings and recorded contents will not be reset.
Data subject to erasure
The information is erased by disconnecting the yellow lead from
the battery (or removing the battery itself).

Some of the settings and recorded contents will not be reset.
Resetting the microprocessor
CAUTION
Pressing the RESET button resets settings and recorded
contents to the factory settings.
—
Do not perform this operation when a device is connected
to this product.
—
Some of the settings and recorded contents will not be
reset.
The microprocessor must be reset under the following
conditions:

Prior to using this product for the first time after installation.
 If this product fails to operate properly.
 If there appears to be problems with the operation of the
system.

If your vehicle position is shown on the map with a signifi-
cant positioning error.
1 Turn the ignition switch OFF.
2 Press the RESET button with a pen tip or other
pointed implement.
 Refer to Checking part names and functions on page 5
Settings and recorded contents are reset to the factory settings.
About this manual
This manual uses diagrams of actual screens to describe opera-
tions. However, the screens on some products may not match
those shown in this manual depending on the model used.
Meanings of Symbols Used in This
Manual
X0000BT
This indicates model name that are supported
the described operations.
This indicates to touch an appropriate soft key
on the touch screen.
HOLD
This indicates to touch and hold an appropri-
ate soft key on the touch screen.
This indicates that there is a reference or
supplementary for the key or screen.
Use and care of the remote
control
Installing the battery
Slide the tray on the back of the remote control out and insert the
battery with the plus (+) and minus (–) poles aligned properly.

When using for the first time, pull out the film protruding
from the tray.
WARNING
 Do not ingest the battery, Chemical Burn Hazard.
 This product, including the supplied remote control,
contains a coin/button cell battery. If the coin/button cell
battery is swallowed, it can cause severe internal burns in
just two hours and can lead to death.

Keep new or used batteries out of the reach of children.
If the battery is swallowed or placed inside any part of the
body, consult a doctor immediately.

If the battery compartment does not close securely, stop
using the product and keep it away from children.

Batteries (battery pack or batteries installed) must not be
exposed to excessive heat such as sunshine, fire or the
like.
CAUTION
 Remove the battery if the remote control is not used for a
month or longer.

There is a danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent type.

Do not handle the battery with metallic tools.
 Do not store the battery with metallic objects.
 If the battery leaks, wipe the remote control completely
clean and install a new battery.

When disposing of used batteries, comply with
governmental regulations or environmental public
institutions’ rules that apply in your country/area.

“Perchlorate Material – special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable
to California, U.S.A.)”
Using the remote control
Point the remote control in the direction of the front panel to
operate.
p
The remote control may not function properly in direct
sunlight.
CAUTION
 Do not store the remote control in high temperatures or
direct sunlight.

Do not let the remote control fall onto the floor, where it
may become jammed under the brake or gas pedal.
Precaution
< CRB4817-A >
Precaution