Installation Guide

15
Installation
Installing the main unit inside the boot, on the floor under a seat, etc.,
using tapping screws
1. Fit the mounting brackets to the sides of the main unit.
2. Fix to the floor with tapping screws.
CAUTION
• Before drilling any mounting holes, confirm that the screws will not interfere
with any of the vehicle’s operating systems (such as the fuel line, brake lines,
electrical wiring, etc.).
Tapping screws
(6 × 16 mm)
Floor
Drill 4 to 4.5 mm
diameter holes.
Use the following holes on
the mounting brackets.
Mounting bracket
Screws (5 × 8 mm)