Operation Manual

1 Touch A.MENU and INITIAL and then
touch DT. WARNING.
2 Touch a to turn warning tone on.
# To turn warning tone off, touch b.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Touch A.MENU and INITIAL and then
touch AUX.
2 Touch a to turn auxiliary setting on.
# To turn auxiliary setting off, touch b.
Selecting the illumination
color
This unit is equipped with two illumination col-
ors, green and red. You can select the desired
illumination color.
1 Touch A.MENU and INITIAL and then
touch ILLUMI.
2 Touch a or b to select the desired illu-
mination color.
Touch a to select GREEN (green). Touch b to
select RED (red).
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (REAR SP FULL) or subwoofer
(REAR SP SUB. W) connection. If you switch
the rear output setting to the
REAR SP SUB. W, you can connect a rear
speaker lead directly to a subwoofer without
using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (REAR SP FULL). When rear out-
put are connected to full range speakers
(when REAR SP FULL is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controllers (low pass filter,
phase) built-in PREOUT SUB.W or the auxili-
ary PREOUT FULL.
! When the multi-channel processor (e.g.,
DEQ-P7000) is connected to this unit, you
cannot operate this function.
1 Touch A.MENU and INITIAL and then
touch REAR SP.
2 Touch a or b to switch the rear output
setting.
Touch a to select full-range speaker and
REAR SP FULL appears in the display. Touch b
to select subwoofer and REAR SP SUB. W ap-
pears in the display.
# When no subwoofer is connected to the rear
output, select REAR SP FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer REAR SP SUB. W.
# When the rear output setting is
REAR SP SUB. W, you cannot change the sub-
woofer controller.
3 Touch c or d to switch the subwoofer
output or non fading output.
Touch c to select subwoofer output and
PREOUT SUB.W appears in the display. Touch
d to select non fading output and
PREOUT FULL appears in the display.
Initial Settings
En
87
Section
18
Initial Settings