Owner's Manual

51
9
Blue/white
Connect to system control terminal of the power amp (max.
300 mA 12 V DC).
a
Light green
Used to detect the ON/OFF status of the parking brake. This
lead must be connected to the power supply side of the
parking brake switch.
b
Power supply side
c Parking brake switch
d Ground side
Speaker leads
1
2








9
a
d
e
7
43
5
6
8
b
c
LR
F/H
R/M
Perform these connections when using a subwoofer without the
optional amplifier.




d
e
43
f
b
c
LR
SW


b
c
g
e
d
h i
1 To power supply
2 Power cord
3 Left
4 Right
5 Front speaker (STD) or high range speaker (NW)
6 Rear speaker (STD) or middle range speaker (NW)
7 White
8 White/black
9 Gray
a Gray/black
b Green
c Green/black
d Violet
e Violet/black
f Subwoofer(4Ω)
g Whenusingasubwooferof2Ω,besuretoconnectthe
subwoofer to the violet and violet/black leads of this unit. Do
not connect anything to the green and green/black leads.
h
Not used.
i Subwoofer(4Ω)×2
When a subwoofer is connected to this product instead of
a rear speaker, change the rear output setting in the initial
setting. The subwoofer output of this product is monaural.

Refer to Switching the rear speaker output on page 41
With a two-speaker system, do not connect anything to the
speaker leads that are not connected to speakers.
Power amp (sold separately)
Without internal amp
Important
The speaker leads are not used when this connection is in
use.












1
1
3
2
4
3
8
55
3
2
6
77
99
2
1
With internal amp
Important
Front speaker and Rear speaker signals (STD) or middle range
speaker and high range speaker signals (NW) are output from
the speaker leads when this connection is in use.




1
3
2
8
99
1 System remote control
Connect to Blue/white cable.
2
Power amp (sold separately)
3 Connect with RCA cable (sold separately)
4 To Rear output (STD)
To middle range output (NW)
5
Rear speaker (STD)
Middle range speaker (NW)
Power cord
1
2
3
4
5
6
7
8
9
a
b
c
b
d
1 To power supply
2 Power cord
3 Yellow
To terminal supplied with power regardless of ignition switch
position.
4
Red
To electric terminal controlled by ignition switch (12 V DC)
ON/OFF.
5
Orange/white
To lighting switch terminal.
6
Black (ground)
To vehicle (metal) body.
7
Violet/white
Of the two lead wires connected to the back lamp, connect
the one in which the voltage changes when the gear shift
is in the REVERSE (R) position. This connection enables
the unit to sense whether the car is moving forwards or
backwards.
8
Yellow/black
If you use an equipment with Mute function, wire this lead
to the Audio Mute lead on that equipment. If not, keep the
Audio Mute lead free of any connections.
51
< CRD4918-A >
Connection Connection