Owner's Manual

39
Setting the video signal
When you connect this product to an AUX equipment, select the
suitable video signal setting.
The default setting is “Auto”.
p
You can operate this function only for the video signal input
into the AUX input.
1 Display the “Video Setup” screen.
2 Touch [Video Signal Setting].
3 Touch [AUX].
4 Touch the item.
The following items are available:
Auto, PAL, NTSC, PAL-M, PAL-N, SECAM.
You can display the video image output by the device connected
to this product.

Refer to External video component and the display on page
56
CAUTION
For safety reasons, video images cannot be viewed while your
vehicle is in motion. To view video images, stop in a safe place
and apply the parking brake.
Starting procedure (for AV
source)
You can display the video image output by the device connected
to video input.
1 Display the “System” setting screen.
2 Touch [Input/Output settings].
3 Touch [AV Input].
X5800BHS X3800BHS
Set the setting to “Source”.
X4800BS X2800BS X1800S
Set the setting to “On”.
4 Display the “AV source selection” screen.
5 Touch [AV].
The image is displayed on the screen.
Starting procedure (for camera)
X5800BHS X3800BHS
You can display the image output by the camera connected to
video input.
1 Display the “System” setting screen.
2 Touch [Input/Output settings].
3 Touch [AV Input] repeatedly, set to “Camera”.
4 Display the “AV source selection” screen.
5 Touch [Camera View].
The image is displayed on the screen.
p
When the camera view of both the rear view camera and 2nd
camera are available, the key to switch the display appears.
Touch this key to switch the display between the rear view
image and 2nd camera image.
Setting the video signal
When you connect this product to an AV equipment, select the
suitable video signal setting.
The default setting is “Auto”.
p
You can operate this function only for the video signal input
into the AV input.
1 Display the “Video Setup” screen.
2 Touch [Video Signal Setting].
3 Touch [AV].
4 Touch the item.
The following items are available:
Auto, PAL, NTSC, PAL-M, PAL-N, SECAM.
AV input
AUX
4821
Full
6/10
Switches between the video input
and the sound input.
p A Mini-jack AV cable (CD-RM10) (sold separately) is required
for connection.

Refer to External video component and the display on page
56
CAUTION
For safety reasons, video images cannot be viewed while your
vehicle is in motion. To view video images, stop in a safe place
and apply the parking brake.
Starting procedure
You can display the video image output by the device connected
to video input.
1 Display the “System” setting screen.
2 Touch [Input/Output settings].
3 Confirm that “AUX Input” is turned on.
4 Display the “AV source selection” screen.
5 Touch [AUX].
The image is displayed on the screen.
AUX source
39
< CRD4924-B >
AUX source AUX source AV input