DVD Player User Manual

Adjusting initial settings
1
1
1
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
Shows the function names.
1 Touch the source icon and then touch
OFF to turn this unit off.
2 Touch the screen to display the touch
panel keys.
3 Touch AV MENU to display the function
names.
The function names are displayed and oper-
able ones are highlighted.
4 Touch ESC to return to the display of
each source.
# To return to the previous display, touch BACK.
Note
You can use AUTO EQ&TA (auto-time alignment
and auto-equalizing), only when STANDARD has
been selected in DSP MODE. (Refer to Switching
the DSP setting mode on the next page.)
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
% Touch DETACH WARNING on the initial
menu to turn warning tone on.
# To turn warning tone off, touch
DETACH WARNING again.
Switching the auxiliary setting
Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 122.
% Touch AUX1/AUX2 on the initial menu
to tur n each auxiliary setting on.
# To turn auxiliary setting off, touch AUX1/
AUX2 again.
Correcting distorted sound
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to LOW. Normally, leave the set-
ting at HIGH to ensure quality sound.
% Touch DIGITAL ATT on the initial menu
to switch the digital attenuator setting.
Touch DIGITAL ATT repeatedly until the de-
sired setting appears in the display.
! HIGH – High quality sound
! LOW – Minimize distortion sound
Initial Settings
En
116
Section
23