Manual

En
65
English
Español
Deutsch
Français
Italiano
Nederlands
13
Section
Initial Settings
Selecting the illumination color
This product is equipped with two illumination
colors, green and red.
You can select the desired illumination color.
1 Press 5 or ∞ to select ILLUMINATION from
the INIT MENU, and press A.MENU.
ILLUMINATION adjustment indications are
displayed.
2 Select the desired illumination color with
2/3.
Pressing 2/3 will switch ILLUMINATION
between RED or GREEN and that status will be
displayed (e.g., ILLUMINATION :GREEN).
Setting the rear output and sub-
woofer controller
This product’s rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (REAR SP:FULL) or
subwoofer (REAR SP:S.W) connection. If you
switch rear output setting to the REAR SP:S.W,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (REAR SP:FULL).
When rear output are connected to full range
speakers (when REAR SP:FULL is selected), you
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass
filter, phase) built-in S.W CTRL:INTERNAL or
the auxiliary S.W CTRL:EXTERNAL.
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 61) or subwoofer output
(refer to page 61) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1 Press 5 or ∞ to select REAR SP from the
INIT MENU, and press A.MENU.
REAR SP adjustment indications are displayed.
2 Change the rear output setting with 5/∞.
Pressing 5/∞ will switch between REAR SP
:FULL (full-range speaker) and REAR SP :S.W
(subwoofer) and that status will be displayed.