Owner's Manual

30
Chapter
66
En
Ground wire
Metal parts of car’s body
POWER AMP
Other devices
(Another electr
onic
device in the car)
When replacing the fuse, be sure to only
use a fuse of the rating prescribed on
this product.
This product cannot be installed in a
vehicle without ACC (accessory) position
on the ignition switch.
A
C
C
O
N
S
T
A
R
T
O
F
F
O
N
S
T
A
R
T
O
F
F
ACC position No ACC position
To avoid short-circuiting, cover the
disconnected lead with insulating tape.
It is especially important to insulate all
unused speaker leads, which if left uncov-
ered may cause a short circuit.
For connecting a power amp or other
devices to this product, refer to the
manual for the product to be connected.
■ Notice for the blue/white lead
When the ignition switch is turned on
(ACC ON), a control signal is output
through the blue/white lead. Connect to
an external power amp’s system remote
control terminal, the auto-antenna relay
control terminal, or the antenna booster
power control terminal (max. 300 mA
12 V DC). The control signal is output
through the blue/white lead, even if the
audio source is switched off.