Owner's Manual

36
Installation
&CAUTION
Never install
this product in places where, or
in
a manner
that:
•
Could injure the driver or passengers if the
vehicle
stops suddenly.
•
May
interfere with the driver's operation of the
vehicle, such as
on
the floor
in
front of the driver's
seat, or close
to the steering wheel or shift lever.
•
To
ensure proper installation,
be sure to use the
supplied parts
in
the manner specified.
If
any parts
are not supplied with this product, use compatible
parts in the manner specified after you have the parts'
compatibility checked by your dealer.
If
parts other
than supplied or compatible ones are used, they may
damage internal parts of this product or
they
may
work
loose and the product may become detached.
•
Do not
install
this product where it may
(i) obstruct
the driver's vision, (ii) impair the performance of any
of the
vehicle's
operating systems or safety features,
including airbags, hazard
lamp
buttons or (iii) impair
the driver's
ability
to safely operate the vehicle.
•
Never install
this product in front of or next to the
place in the dashboard, door, or
pillar
from which one
of your vehicle's
airbags would deploy. Please refer
to your
vehicle's
owner's manual for reference to the
deployment area of the frontal airbags.
• Consult
with your nearest dealer if installation requires drill-
ing holes or other
modifications
of the vehicle.
•
Before making a final installation of this product. temporar-
ily
connect
the wiring
to
confirm
that the connections are
correct and the system works properly.
•
Do
not
install
this
product
in places subject
to
high tempera-
tures or humidity, such as:
• Places
close to a heater, vent
or
air conditioner.
• Places
exposed to direct sunlight, such
as
on
top
of the
dashboard.
• Places
that may be exposed to rain , such as close to the door
or
on the vehicle's floor.
• Install
this product horizontally
on
a surface
within
0
to
30
degrees tolerance
(w
ithin 5 degrees to the left or right).
Improper
installation of the
unit
with the surface tilted more
than these tolerances increases the potential for errors
in
the
ve
hicle's
lo
cation display, and
might
otherwise cause
reduced display performance.
•
When installing,
to
ensure proper heat dispersal when using
this unit, make sure you leave ample space behind the rear
panel and wrap any loose cables so they are not blocking the
vents.
Leave
ample
space
Fastening this product to the factory radio-
mounting bracket.
Position
this
product so that its screw holes are aligned with
the
screw holes of the bracket, and tighten the screws at three
locations
on
each side.
Use either the truss head screws
(5
mm
x
9
mm)
or
flush
surface screws
(5
mm
x
9 mm), depending
on
the shape of the
bracket's screw holes.
..............
~
00
00&'
~
0fE
CD
Factory radio-mounting bracket
(g)
If
the pawl interferes
with
installation, you may
bend
it down
out of the way.
®
Dashboard
or
console
@)
Truss head screw
or
flush surface screw
Be
sure
to
use
the
screws supplied with
this
product.
voice.
•
Be sure
to
turn
off
(ACC
OFF)
the product before
connecting
the microphone.
•
Depending
on
the
vehicle model.
the
microphone cable
length may
be
too
short
when you
mount
the microphone on
the sun visor.
In
such
cases,
install
the microphone on
the
steering column.
Fit the microphone
lead
into the groove.