Installation Manual

Installation
03
Installation
Chapter
17
En
English
• When installing, to ensure proper heat
dispersal when using this unit, make
sure you leave ample space behind the
rear panel and wrap any loose cables so
they are not blocking the vents.
Leave ample
space
5 cm
5 cm
• Do not squeeze this product into the
holder. It may damage the front panel.
Parts supplied
The display unit
Flush surface screw
(5 mm × 9 mm)
(6 pcs.)
Truss head screw
(5 mm × 8 mm)
(6 pcs.)
Installation using the screw holes
on the side of this product
1 Fasten the unit to the factory radio-
mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three or four lo-
cations on each side. Use either the truss
head screws (5 mm × 8 mm) or flush surface
screws (5 mm × 9 mm), depending on the
shape of the bracket’s screw holes.
If the tab interferes with installation,
you may bend it down out of the way.
Factory radio-mounting bracket
Truss head screw or
flush surface screw
Be sure to use the
screws supplied
with this product.
Dashboard or console
CRD4687AN.indb 17 2013/04/05 12:57:32