User guide

ManualsBrandsPioneer ManualsCar MultimediaANH-P10MP

Audio Adjustments

En

11

Section

88

2Press LOUD to turn the loudness on.

“LOUDNESS ON” appears in the display.





Press LOUD again to turn loudness off.

3 Select the desired level with 



or 



.

Press 



or 



until the desired level appears in

the display.

LOW—MID—HIGH

Using subwoofer output

This product is equipped with a subwoofer

output which can be switched on or off. When

a subwoofer is connected to the rear output,

first, switch the rear output setting to

“SUB.W”, then turn the subwoofer output on.

For more details, refer to Setting the rear out-

put and subwoofer controller on page 94.

1Press AUDIO and then press NEXT.

2Press SW 1 to select the subwoofer

output mode.





When the subwoofer controller setting is

“FULL Preout :FULL”, you cannot select “SW 1”.

3Press SW 1 to turn the subwoofer out-

put on.

“SUB. W ON” appears in the display.





Press SW 1 again to turn subwoofer out-

put off.

4Press 



or 



to select the phase of sub-

woofer output.

Press 



to select reverse phase and the

speaker appears facing downward. Press 



to

select normal phase and the speaker appears

facing upward.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-

just the cut-off frequency and the output level

of the subwoofer.

1Press AUDIO and then press NEXT.

2Press SW 2 to select the subwoofer

setting mode.





When the subwoofer output is on, you can se-

lect SW 2.

3Press 



or 



to select cut-off frequen-

cy.

Each press of 



or 



selects cut-off frequen-

cies in the following order:

50—80—125 (Hz)

Only frequencies lower than those in the se-

lected range are output from the subwoofer

(low pass filter).

4Press 



or 



to adjust the output level

of the subwoofer.

Each press of 



or 



increases or decreases

the level of the subwoofer. “+6” – “–6” is dis-

played as the level is increased or de-

creased.

Using nonfading output

When the non fading output setting is on, the

audio signal does not pass through this prod-

uct’s low pass filter (for the subwoofer), but is

output through the RCA output.

1Press AUDIO and then press NEXT.

2Press NoFAD1 to select nonfading out-

put on/off setting mode.





Only when the subwoofer controller setting is

“FULL Preout :FULL”, you can switch to the non-

fading output on/off setting. (Refer to Setting the

rear output and subwoofer controller on page 94.)