Instruction Manual

Setting the Navigation
En
27
<CRD3863-A> 28
2 Using the rotary stick, select MODIFY and
press to confirm.
3 Unit rotation can be selected in degrees
by turning the rotary stick and pressing to
confirm.
Unit rotation corresponds to horizontal rotation.
A positive value means rotation of the front of
the unit towards the driver (LHD).
4 The unit inclination can now be selected
in degrees by turning the rotary stick and
pressing to confirm.
Unit inclination corresponds to vertical inclina-
tion. A positive value means upward inclination
of the front of the unit.
5 The number of wheel impulses per wheel
revolution (if known) can then be selected
by turning the rotary stick and pressing to
confirm.
If the number of wheel impulses per wheel revo-
lution is not known, UNKNOWN must be
selected. The entering of tyre data is than not
available.
6 The previously entered data is displayed
once more. If the data entered is correct,
press the NAVI/OK button.
If correction is necessary, select MODIFY by
turning the rotary stick and press to confirm.
The values can then be re-entered.
Once the previously entered data is confirmed,
the tyre data can be entered or self-calibration
can be started.
7 To enter the tyre data, select
INPUT TYRE
VALUES by turning rotary stick and press to
confirm.
CRD3863A_inst_002-029_UK 4/9/04 2:05 PM Page 28