Manual

Controls and displays 03
11
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Remote control
1 AMP 
Switches the amplifier between standby and
on.
2 Input selector buttons
Press to select an input source. These select
the component connected to the
corresponding input on the rear panel.
3 TONE/BAL controls
Use to adjust the tone and balance (page 12).
4 VOLUME +/–
Use to set the listening volume.
5 MUTE
Mutes/unmutes the sound.
6 DIMMER
Dims or brightens the display (or switches the
backlight off).
7DIRECT
Press to access Direct listening (page 12).
8 CD PLAYER control buttons
Use to control Pioneer CD player.
9 TUNER control buttons
Use to control Pioneer tuner.
Using the remote control
Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles
between the remote and the remote sensor
on the unit.
• The remote has a range of about 7 m at an
angle of about 30º from the remote sensor.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit’s remote sensor.
• Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.
• Replace the batteries when you notice a fall
off in the operating range of the remote.
1
6
7
8
2
3
4
5
9
INTEGRATED AMPLIFIER
AMP DIMMER
CD TAPE PHONO
TUNER AUX DIRECT
LR
VOLUME
MUTE
CD PLAYER
TUNER
BAND PRESETPRESET
TONE/BAL
A6MK2_SYXCN5.book 11 ページ ２００９年４月７日 火曜日 午前１１時１８分