User Manual
Appendix
30
En
Troubleshooting
Common
Symptom Cause Action
The power will not turn
on. The unit will not
operate.
Leads and connectors are
incorrectly connected.
Conrm once more that all
connections are correct.
The fuse is blown.
Rectify the cause and then replace
the fuse. Be sure to install a fuse
with the same rating.
Noise and/or other factors
are causing the built-in
microprocessor to operate
incorrectly.
Press [RESET].
The power isn’t enabled
correctly.
Press [
/MUTE ] button to turn
on the unit.
Operation with the remote
control is not possible.
The unit does not operate
correctly even when
the appropriate remote
control buttons are
pressed.
Battery power is low. Load a new battery.
There is no sound.
The volume level will not
rise.
Cables are not
connected correctly.
Connect the cables
correctly.
The aspect ratio is
incorrect and the image is
stretched.
The aspect ratio setting is
incorrect for the display.
Select the appropriate setting for
your display.
There is no
image displayed.
The parking
brake cable is
not connected.
Connect the parking
brake cable,
and apply the parking
brake.
The image displayed
stops (pauses) and the
unit cannot be operated.
The data could no longer
be read during playback.
Stop playback once, and start
playback again.
There is no sound.
The volume level is low.
The volume level is low. Adjust the volume level.
The sound and video
skip.
The unit is not rmly
secured.
Firmly secure the unit.
Sub-folders cannot be
played back.
Folder repeat play has
been selected.
Select the repeat range again.
Additional information