Installation & Assembly

REV-12 10, 12

Faucet Installation

3. Connect the valve inlets (L) to inlet supply lines (M). Then connect the

supply stops (N) to the inlet supply lines (M) (left is hot water supply and

right is cold water supply). Make sure inlet supply lines (M) are securely

tighten. Do not overtighten.Turn on supply stops (N). Check for any

leaks. Make sure all the connections are secure.

4. Remove aerator (O). Open the handle. Flush and allow water to run at

fullowforatleastoneminute.Replaceaerator(O).