Installation & Assembly

REV-12 10, 12

Faucet Installation

Note• :- The faucet spout (A) is supplied with rubber washer (B) to form

watertight seal. Do not use rubber washer and plumbers putty both to

form watertight seal.

Insert the spout (A) through mounting hole. Slide the spout mounting 1.

plate (C) through the spout shank. Thread and tighten the spout mount-

ing nut (D). Thread the spout & valve hose connector (E) underneath the

spout shank.

Note:- • Do not put extra force on Spout (A) after installation. Spout is

designed as rigid spout If extra force put on spout It can swivel.

Note• :- The valve escutcheon (H) is supplied with gasket (I) to form

water tight seal. Do not use gasket (I) and plumbers putty both to form

watertight seal.

2. Place the escutcheon (H) on top of mouning hole. Ensure the gasket (I)

is beneath the escutcheon (H). Slide the valve (F) through the escutch-

eon and the mounting hole.

Slide the mounting bracket (J) through spout port (G). Thread the spout •

mounting nut (K) and use supplied socket tool to tighten the spout

mountingnut(K).Donotovertighten.Applyteontapetothreadedcon-

nection if needed. Connect spout & valve hose connector (E) to spout

port (G).