Installation & Assembly

ManualsBrandsPioneer ManualsChrome Kitchen FaucetsPremium Single Handle Kitchen Faucet

Installation Guide

Single Handle Bar Faucet:

5PM330•

This product meets the following standards:

ASME A112.18.1 •

ANSI A117.1 •

ANSI / NSF 61, SECTION 9 •

ADA COMPLIANT•

CONTAINS NO MORE THAN 0.25% WEIGHTED •

AVERAGE LEAD CONTENT

REV-12 10, 12

Engineering Excellence

Engineering E xcellence

Summary of content (7 pages)

PAGE 1
Engineering Excellence Engineering E xcellence Installation Guide Single Handle Bar Faucet: • 5PM330 This product meets the following standards: • • • • • ASME A112.18.1 ANSI A117.1 ANSI / NSF 61, SECTION 9 ADA COMPLIANT CONTAINS NO MORE THAN 0.25% WEIGHTED AVERAGE LEAD CONTENT Pioneer Industries, Inc.
PAGE 2
Thank you for purchasing this pioneer quality product. Tools Required Adjustable Wrench Teflon Tape Rags 1/8” Allen Wrench Prior to Installation • Observe all local plumbing and building codes before you begin installation. • Carefully shut off hot and cold water supplies. • Plug the sink drain with a soft cloth to prevent intrusion of debris or the loss of any parts. • Pioneer reserves the right to make changes in the design of faucets without notice.
PAGE 3
Faucet Installation • 1. • • 2. • Note:- The faucet spout (A) is supplied with rubber washer (B) to form watertight seal. Do not use rubber washer and plumbers putty both to form watertight seal. Insert the spout (A) through mounting hole. Slide the spout mounting plate (C) through the spout shank. Thread and tighten the spout mounting nut (D). Thread the spout & valve hose connector (E) underneath the spout shank. Note:- Do not put extra force on Spout (A) after installation.
PAGE 4
Faucet Installation Drawing 4 REV-12 10, 12
PAGE 5
Faucet Installation 3. 4. Connect the valve inlets (L) to inlet supply lines (M). Then connect the supply stops (N) to the inlet supply lines (M) (left is hot water supply and right is cold water supply). Make sure inlet supply lines (M) are securely tighten. Do not overtighten.Turn on supply stops (N). Check for any leaks. Make sure all the connections are secure. Remove aerator (O). Open the handle. Flush and allow water to run at full flow for at least one minute. Replace aerator (O).
PAGE 6
Faucet Installation Drawing For more care information or trouble shooting inquiries about your Pioneer Product, please see the contact information on the back page.
PAGE 7
Engineering Excellence Engineering E xcellence 3325 S. Garfield Ave. | Commerce, CA 90040 Telephone: (800) 338-9468 | (323) 888-8873 | Fax: (323) 888-9515 Hours: M - F, 7:30am to 5:00pm PST www.pioneerind.