Operation Manual

12Appendix
English
39
En
Problem
• No power.
• No picture or sound
• Normal picture but no sound
• No picture or black and white
picture
• Sound and picture interference
• Blurred or snowy picture, distorted
sound
•Remote control malfunctions
Troubleshooting
Possible Solution
• Make sure the Plasma Display is connected correctly. (See page 17.)
• Is the power cord disconnected? (See page 17.)
•Has the power been turned on? (See page 18.)
• Check if you have pressed
on the remote control unit. (See page 18.)
If the STANDBY indicator on the Plasma Display lights up red, press .
• Check if the power cord is connected correctly.
• Check if you have pressed the
on the remote control or the STANDBY/ON button on the bottom
of the Plasma Display.
• Select an input source responding to that particular source.
• Check the picture contrast and brightness settings.
• Check the volume.
• Check the volume.
• Check whether the button on the remote control has been pressed.
•Adjust the colour settings.
• Check if the correct broadcast system is selected.
•Try to identify the electrical appliance that affects the Plasma Display, then move it further away.
• Plug the power cord of the Plasma Display into a different wall outlet.
• Check the direction, location and connections of your aerial. Such interference often occurs due to
the use of an indoor aerial.
•Press the INPUT button to select the Plasma Display or an external device.
•Replace the batteries in the remote control.
• Install batteries ensuring that the <+> and <
–
> ends of the batteries are inserted correctly.
• Check the angle and distance of the remote control to the Plasma Display. Make sure there are no
obstacles between the remote control and the Plasma Display.
• Check if the correct function button has been pressed.
• Change the location of light sources or the direction of the Plasma Display to avoid glare.
• Is the Teletext function activated? (See page 38)
12 Appendix
13-PDP42RXE-Eng (39-42) 9/30/05, 12:16 PM39