Installation & Assembly

INSTALLATION
Tools:
Adjustable Wrench Plumbers Putty Teon Tape Rags
Model Number: 3MO200
Warnings and Notes:
Check with local plumbing code requirements before installation.
This product should be installed by a local listed plumber.
Do not use plumbers putty on threads.
Installation Steps:
Two Handle Lavatory Widespread Faucet
(1) Shut off water supplies. Remove old faucet.
Clean mounting surface in preparation for new
faucet.
(2) Place spout ange under the spout. Ensure
there is a washer under the spout ange.
Place the spout in position on the sink. From
under the sink slide mounting bracket through
spout shank. Thread nut onto spout shank
properly and tighten nut.
(3) Thread Y connector to the spout shank.
Ensure there is a washer in the Y connector.
Do not overtighten.
(4) Place hot and cold side valve in position on
the sink. From under the sink place washers
and thread locknut with the help of 1-11/32”
size socket.
PIONEER INDUSTRIES, INC.
3325 S. Gareld Ave
Commerce, CA 90040
(800) 338-9468
www.pioneerind.com
(5) Connect both hot and cold side valve
outlet hose to Y connector.
(6) Install the inlet hoses to the main
supply stops. Turn on supply stops.
Check for any leaks. Make sure all the
connections are secure. Remove aerator.
Turn on both hot and cold water and let
water run at least one minute. Then turn
off water and replace aerator.
(1) Remove pop-up ange from body
Pop-up Drain Installation:
(2) Place a ring of putty on the bottom of
ange.
(3) Insert pop-up ange through drain
hole and attach ange to body. Ensure
the pop-up outlet faces towards the back
of the sink. Tighten the locknut securely
with a wrench. Do not overtighten.
(4) Remove the excess putty. Connect the
trap (check manufacturer’s instructions for
installation).
MOD Series

Summary of content (2 pages)