Installation & Assembly

4
REV-11 19, 12
Pop-up Drain Installation
Removethepop-upstopper(E)andpop-upange(F)fromthepop-up1.
assembly.
Applyadequateamountofplumbersputtyundersideofpop-upange2.
(F). Then insert pop-up drain assembly from underside of the sink and
securethepop-upange(F)fromthetop.
Rotate the drain body so that horizontal rod hole faces back of the fau-3.
cet.Hold the pop-Up assembly in place and tighten the locknut (G).
Remove the excess putty. Connect the trap (H) ( check manufacturer’s 4.
instructions for installation).
Remove rod nut (I).5.
Ensure the washers (K) is in place (for brass pop-up only). Insert rod (J). 6.
Tighten the rod nut (I).
Push rod down to open drain. Insert the pop-up stopper (E) carefully. 7.
Test if the pop-up stopper (E) is working properly.
Connect pop-up bracket to the rod using clip (L). Tighten the thumb-8.
screw (M) to connect pop-up bracket to pop-up lift rod.