Installation & Assembly

ManualsBrandsPioneer ManualsChrome Kitchen FaucetsMotegi Pull Down Single Handle Kitchen Faucet

Installation Guide

Single Handle Kitchen Faucet:

2GB250•

2CL250•

2MT250•

2LG250•

This product meets the following standards:

ASME A112.18.1 •

ANSI A117.1 •

ANSI / NSF 61, SECTION 9 •

CUPC / IAPMO LISTED / ADA COMPLIANT•

CONTAINS NO MORE THAN 0.25% WEIGHTED AVERAGE •

LEAD CONTENT

REV-01 25, 13

Engineering Excellence

Engineering E xcellence

Summary of content (7 pages)

PAGE 1
Engineering Excellence Engineering E xcellence Installation Guide Single Handle Kitchen Faucet: • • • • 2GB250 2CL250 2MT250 2LG250 This product meets the following standards: • ASME A112.18.1 • ANSI A117.1 • ANSI / NSF 61, SECTION 9 • CUPC / IAPMO LISTED / ADA COMPLIANT • CONTAINS NO MORE THAN 0.25% WEIGHTED AVERAGE LEAD CONTENT Pioneer Industries, Inc.
PAGE 2
Thank you for purchasing this Pioneer quality product. Tools Required Adjustable Wrench Teflon Tape Plumbers Putty Rags Prior to Installation • Observe all local plumbing and building codes before you begin installation. • Carefully shut off both hot and cold water supplies from under the sink. • Plug the sink drain with a soft cloth to prevent intrusion of debris or the loss of any faucet parts.
PAGE 3
Faucet Installation • 1. 2. Clean the mounting surface If necessary. For three hole installation :- Apply plumbers putty or sealant to the bottom of the base gasket (E). Align the base gasket (E) on the mounting surface and press into place. Remove excess plumbers putty. Slide the deck plate (D) through the hoses underneath of the faucet. Insert the faucet through mounting surface hole. For single hole installation :- Note:- The faucet escutcheon is supplied with rubber washer to form watertight seal.
PAGE 4
Faucet Installation 3. 4. Slide the mounting kit (F) along with shank from underneath of the mounting surface. Thread the mounting kit (F) with the help of provided mounting tool (J). Do not overtighten.
PAGE 5
Faucet Installation 5. 6. 7. Use main supply hose(K) to connect hot and cold inlet hose to main supply stop(L). Tighten with adjustable wrench. Do not overtighten. Install the weight along with the spray hose(C) such a way that pull down spray head easily retractable. Connect the spray hose(C) to the spray head outlet(A). Do not overtighten. Turn on main supply stops. Check of any leaks. Make sure all the connection are secure.
PAGE 6
To Set or Adjust Temperature Limit Stop Caution: Valve is preset at the factory test at maximum. Adjust as necessary. Please see the instructions below: • Turn off main supply stop and relieve the pressure. • Remove handle(M) by loosening set screw(N) lift off the handle. • Unscrew retainer ring(O) and locknut(P) counterclockwise. • Use two fingers to raise the red adjusting ring(Q). • Turn adjustment ring counterclockwise to decrease the temperature setting and clockwise to increase the temperature.
PAGE 7
Engineering Excellence Engineering E xcellence 3325 S. Garfield Ave. | Commerce, CA 90040 Telephone: (800) 338-9468 | (323) 888-8873 | Fax: (323) 888-9515 Hours: M - F, 7:30am to 5:00pm PST www.pioneerind.