User manual

Bluetooth ® Audio playback
41
13
4 Confirm on the Bluetooth capable device
that pairing has been completed.
If pairing with the Bluetooth capable device has been
completed correctly, the name of the Bluetooth capable
device will be displayed on the front panel of the unit. (Only
single-byte alphanumeric characters can be displayed. Any
character that cannot be displayed will be indicated by a “”.)
On BT CONNECT LED display
Listen to music on the unit from a
Bluetooth capable device
1 Press the BT AUDIO .
The unit will switch to BT AUDIO input.
2A Bluetooth connection will be created
between the Blu etooth capable device and the
unit.
Procedures for connecting to the unit should be performed
from the Bluetooth capable device.
• Please refer to the user’s manual for your Bluetooth
capable device for details of the connection procedures.
3 Playback music from the Bluetooth capable
device.
BT STANDBY
• The following can be done when the unit is on standby
with the BT STANDBY switched ON.
• By selecting a Bluetooth capable device that already has
a connection history (pairing has already been
conducted) with this unit, this unit will automatically
turn on with the BT AUDIO function.
BT STANDBY settings
1 Press HOME MENU .
2 Press
/ to select “ Network Standby ”,
then press
ENTER .
3 Press
/ to select “ ON ”, then press ENTER .
Connection while in BT STANDBY mode with
Bluetooth capable device
When connection history (pairing has already been
conducted) with a Bluetooth capable device exists for the unit
during BT STANDBY, the unit can receive a connection
request directly from the connection history.
The unit will start using the BT AUDIO function, and connect
with a Bluetooth capable device.
Even devices that have already been paired with this unit will
not connect during BT STANDBY in the following cases.
In such cases, delete pairing history from the Bluetooth
wireless technology device and perform pairing again.
• Up to 8 pairing history can be recorded with this unit. If
connecting to a Bluetooth wireless technology device
over 8 units, the oldest pairing history will be deleted.
• If the settings are reset to the factory setting, all pairing
history will be deleted.
Switch the BT AUDIO function on or off
If you wish to switch the BT AUDIO function between on or off,
then perform the following settings.
The factory setting is ON.
1 Press INPUT SELECT on the front panel and
VOLUME – at the same time and hold them for
three seconds.
2 Press
/ on the remote control to select
“
ON ” or “ OFF ”, then press ENTER on the remote
control.
3 Wait 60 seconds until “
BT Setting ”
disappears.
Once “BT Setting” disappears then settings are complete.
Pairing condition LED display
Pairing standby Slow flashing
Pairing completed Lit up
SBX-B70D.book 41 ページ ２０１５年４月１３日 月曜日 午後２時６分