User manual
Connect network 08
25
• Select [Next].
• Wait until the processing is complete.
• Select [Complete].
Note
• This screen is iOS 7.1. When software other than iOS 7.1
is installed on an iPhone or iPod touch, the operation for
the iPhone or iPod touch may change.
• Even when using a Mac OS, if “Set new AIRPLAY
speaker” is displayed on the “Wi-Fi” setting screen then
it may be possible to perform settings using the controls
described above.
D: WPS connection settings
WPS is an abbreviation for “Wi-Fi Protected Setup”. This is a
standard stipulated by the Wi-Fi Alliance, and connection to
WPS compatible equipment and security settings can be
performed using simple operations.
This unit is compatible with PBC (push button) method.
• PBC (Push-button method) – Connection settings are
automatically done by simply pressing the WPS button
on wireless LAN equipment that is WPS-compatible.
Follow the instructions shown on the screen of this unit.
This setting method is available when there is a WPS
button on the wireless LAN equipment which is WPS-
compatible, and is the easiest method for connection
settings.
• Check that your router is compatible with PBC.
• Check that the LAN cable is not connected to this unit.
• When wired LAN is set once, the following procedures 1
through 3 must be executed.
1Select “
Network Type Set
” from the
HOME
MENU
.
2Use
/
to select “
Wireless
”.
3 Press
ENTER
.
The home menu will be disabled for about 60 seconds. After
60 seconds, execute the following operation.
4 Press
NETWORK SET UP
and
INPUT SELECT
on the front panel together for 3 seconds.
The NETWORK indicator will flash blue.
5 Press your router’s WPS button within 2
minutes.
Please refer to your router’s user manual for details on router
operation.
6 Network connection settings will be
performed automatically.
Once settings are completed the NETWORK indicator will
change from flashing blue to remaining lit white.
*****
XXXXXX
XXXXXX
SBX-B70D *****
XXXXXX
SBX-B70D ***** ...
XXXXXX
SBX-B70D.book 25 ページ ２０１５年４月１３日 月曜日 午後２時６分