User manual

Connect network08
24
4 Unlock the iPod/iPhone.
Check that the Wi-Fi operation mark is shown on the screen
of the iOS equipment.
5 Connect the iOS equipment to the iPod/
iPhone terminal on the front panel.
6 Press
NETWORK SET UP on the front panel.
7 Tap [
Allow ] on iPod/iPhone.
The Wi-Fi settings of your iPod/iPhone is applied to this unit.
C: Perform this unit's settings using
the iOS equipment (iOS version 7.1 or
later)
The Wi-Fi settings of your iPod/iPhone (equipment with iOS
version 7.1 or later) can be applied to this unit.
• The iOS equipment and router must be connected
through Wi-Fi.
• Check that the LAN cable is not connected to this unit.
• When wired LAN is set once, the following procedures 1
through 3 must be executed.
1 Select “ Network Type Set ” from the HOME
MENU
.
2Use
/ to select “ Wireless ”.
3 Press
ENTER .
The home menu will be disabled for about 60 seconds. After
60 seconds, execute the following operation.
4 Unlock the iPod/iPhone.
Check that the Wi-Fi operation mark is shown on the screen
of the iOS equipment.
5 Press NETWORK SET UP and VOLUME – on
the front panel together for 3 seconds.
6 The unit will enter WAC mode.
WAC (Wireless Accessory Configuration) mode is a mode
that allows you to set the network settings by operating this
unit as a Wi-Fi access point.
7 Operate the screen of the iPhone or iPod
touch.
• Check that the Wi-Fi mark is displayed on the screen of
the iPhone or iPod touch.
If the mark is not displayed, activate Wi-Fi, and connect
the iPhone or iPod touch to a wireless LAN router.
• Select the settings.

• Select [Wi-Fi].

• In [Set new AIRPLAY speaker], select Friendly Name (iOS
7) or SSID (iOS 6 or older).
Share Wi-Fi Settings?
Ignore
XXXXXX
SBX-B70D *****
XXXXXX
SBX-B70D.book 24 ページ ２０１５年４月１３日 月曜日 午後２時６分