User manual

USB playback 07
19
Chapter 7:
USB playback
Playing USB storage devices
It is possible to listen to two-channel audio using the USB
interface on the side of this unit.
• Pioneer does not guarantee that any file recorded on a
USB storage device will play or that power will be
supplied to a USB storage device. Also note that Pioneer
will accept no responsibility whatsoever for loss of files
on USB storage devices caused by connection to this
unit.
1 Press USB as the input source.
“USB/iPod” is shown on the main display.
2 Connect the USB storage device.
• This unit does not support a USB hub.
3 When recognition is completed, the root
directory folder/file name will be shown on the
display.
4 Press
/ to select a folder/file, then press
ENTER .
Select a folder and the folders/files inside it will be displayed.
Select a file and playback will start.
5 Disconnect USB storage device from the USB
terminal.
Note
• USB flash drive that supports USB 2.0 can be used.
• This unit may not recognize a USB storage device, play
files or supply power to a USB storage device. For
details, see When a USB storage device is connected on
page 49.
• When a USB storage device is not playing and no
operations have been performed for more than 20
minutes, the unit will automatically power off.
• Auto power off can be switched to ON/OFF (page 43).
• Installing the ControlApp to your mobile device and then
connecting it to this unit will allow for more convenient
control (page 31).
Repeat play
Repeat play can play one track, all tracks or a programmed
sequence continuously.
To repeat one track:
Press REPEAT repeatedly until “REPEAT ONE” appears. Press
ENTER.
To repeat all tracks:
Press REPEAT repeatedly until “REPEAT ALL” appears. Press
ENTER.
To cancel repeat play:
Press REPEAT repeatedly until “REPEAT OFF” appears. Press
ENTER.
Note
• After performing repeat play, be sure to press .
Otherwise, the file of USB storage device will play
continuously.
Random play
The file of USB storage device can be played in random order
automatically.
To random play all tracks:
Press RANDOM repeatedly until “RANDOM ON” appears.
Press ENTER.
To cancel random play:
Press RANDOM repeatedly until “RANDOM OFF” appears.
Press ENTER.
Note
• In random play, the unit will select and play tracks
automatically. (You cannot select the order of the tracks.)
Switch the display contents
The unit can display the information recorded in the USB
storage device.
1 Press DISP .
The information recorded in the USB storage device will be
displayed on the unit’s display
USB storage device
(commercially available)
SBX-B70D.book 19 ページ ２０１５年４月１３日 月曜日 午後２時６分