Installation Guide

5
REV-12 13, 12
Handheld Showerset Installation
6. Apply sealant tape to the inlet from main or diverter valve(J). Install
the drop ell(I) to the inlet from main or diverter valve(J). Use silicon
to caulk around the drop ell(I) if necessary to create water tight seal.
Install vacuum breaker(H) underneath of the drop ell(I). Connect the
hose(F) to the vacuum breaker(H). Do not forget to put the washer(G)
in the hose(F). The other end of the hose(F) connect it to handheld
showerhead(E).
Turn on the inlet water supply. check for any leaks. •
For more care information or trouble shooting inquiries about your
Pioneer Product, please see the contact information on the back page.