Installation Guide

REV-11 19, 12

Valve Installation

7. Slide the rubber & steel washer (G,H) on the hot side valve from the top.

Thread locknut(F) from the top.

8. Place the valve from the mounting hole.

9.Adjustthelocknut(F)sothatthedistancebetweennishedsurfaceand

top of the valve is 1-3/4”.

10. Tighten rubber and steel washer (G,H) and locknut (F) from underneath

with the help of 1-7/16” socket or adjustable wrench. Install Cold side

valve as the same way.

11. Carefully install the hose (I) to the valve outlets. The other end connect it

to ‘T ‘ connector (E).

12. Do not over tighten the hose with adjustable wrench as it may damage

the valve assembly.