Installation Guide

REV-11 19, 12

Faucet Installation

5. The hot and cold side valves(H) are marked with ‘HOT’ and ‘COLD’ on

the valve. Place washer(I) underneath of the ‘HOT’ side valve. Slide

the valve through mounting hole. Place rubber washer(J) and steel

washer(K) to the valve from underneath of the mounting surface.

6. Ensure the handles are position correctly. Tighten the locknut(L) to the

valve(H) with the help of 1-11/32” socket. Install the ‘COLD’ side valve

same as ‘HOT’ side valve.

7. Connect the valve outlet hose connector(M) to the cross connector(F).

8. Connect HOT and COLD inlet to inlet supply lines carefully. Ensure all

the connections are installed correctly.