User Manual

137
Setup
Audio AdjustAudio Adjust
 Dual Mono/Mono
Change the settings of multiplex audio playback.
 Dual Mono (Default Value: Main)
Set the audio channel or language to be output when playing multiplex audio or
multilingual broadcasts, etc.
• For multiplex audio broadcasts, pressing the
button on the remote
controller will display "1+1" on the main unit’s display.
Main Main channel only
Sub Sub channel only
Main / Sub Main and sub channels will be output at the same time.
 Mono Input Channel (Default Value: Left + Right)
Set the input channel when playing back analog or 2 ch PCM signals in the
Mono listening mode.
Left Left channel only
Right Right channel only
Left + Right Left and right channels
 Dolby
Change the setting of when Dolby signals are input.
 Loudness Management (Default Value: On)
When playing Dolby TrueHD, enable the dialog normalization function which
keeps the volume of dialog at a certain level. Note that when this setting is "Off",
the Midnight function that allows you to enjoy surround at low volumes is xed to
"Off" when playing Dolby Digital Plus/Dolby TrueHD.
On When this function is used
Off When this function is not used
 Center Spread (Default Value: Off)
Adjust the width of the front sound eld created when playing back with the
Dolby Audio - Surr listening mode.
• Depending on the speaker settings, "Off" is applied.
On The sound eld is spread to left and right.
Off The sound eld is centralized.