User Manual

93
Playback
Playing Back (ZONE 3)
In the remote controller operation, while pressing and holding the ZONE 3
SHIFT button on the remote controller, operate with each button. Settings are
required to playback a source in ZONE 3.
Set "Speaker" - "Conguration" - "Zone Speaker" ( →p115) in the System
Setup menu to "Zone 2/Zone 3".
1. Point the remote controller at the unit, and while pressing and holding the
ZONE 3 SHIFT button on the remote controller, press .
• "Z3" on the display of the main unit lights up.
2. While pressing and holding the ZONE 3 SHIFT button on the remote
controller, press the input selector of the input source you want to play in the
separate room. When operating on the main unit, press the ZONE CONTROL
button repeatedly to select "Z3" on the display, then within 8 seconds select
the input you want to play in another room using the input selector dial.
3. To adjust the volume of the ZONE speakers in the separate room, press
the volume buttons while pressing the ZONE 3 SHIFT button on the remote
controller. When operating on the main unit, press the ZONE CONTROL
button repeatedly to select "Z3" on the display, then within 8 seconds adjust
using the MASTER VOLUME knob.
• If you turn the unit to standby during multi-zone playback, the Z3 indicator is
dimmed, and the playback mode is switched to playback in a separate room
only. Setting ZONE 3 to on while the unit is in standby also switches the
playback mode to playback in a separate room only.
• For ZONE 3 output, audio from externally connected AV components can be
output only when it is an analog audio signal.
• DSD audio signals cannot be output to ZONE 3 when selected with the "NET"
or "USB" input selector.
• If ZONE 3 is on, power consumption during standby will increase.
• This function turns off if you use the Bluetooth Transmitter ( →p64).
To set the function to off: While pressing and holding ZONE 3 SHIFT button,
press
. Alternatively, press the ZONE 3 ON/OFF button on the main unit.
1
2