User Manual

109
Setup
Audio AdjustAudio Adjust
 Dual Mono/Mono
Change the settings of multiplex audio playback.
 Dual Mono (Default Value: Main)
Set the audio channel or language to be output when playing multiplex audio or
multilingual broadcasts, etc.
• For multiplex audio broadcasts, pressing the
button on the remote
controller will display "1+1" on the main unit’s display.
Main Main channel only
Sub Sub channel only
Main / Sub Main and sub channels will be output at the same time.
 Mono Input Channel (Default Value: Left + Right)
Set the input channel to play 2 ch digital sources such as Dolby Digital, or 2 ch
analog/PCM sources in the Mono listening mode.
Left Left channel only
Right Right channel only
Left + Right Left and right channels
 Dolby
Change the setting of when Dolby signals are input.
 Loudness Management (Default Value: On)
When playing Dolby TrueHD, enable the dialog normalization function which
keeps the volume of dialog at a certain level. Note that when this setting is "Off",
the Midnight function that allows you to enjoy surround at low volumes is xed to
"Off" when playing Dolby Digital Plus/Dolby TrueHD.
On When this function is used
Off When this function is not used
 DTS
Change the setting of when DTS signals are input.
 Dialog Control (Default Value: 0 dB)
You can increase the volume of dialog portion of the audio up to 6 dB by 1 dB
step so that you can hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not be selected.