Full Product Manual

18 PINNACOLO L’ARGILLA THERMAL CLAY GAS POWERED OVEN
BURNER WILL NOT LIGHT
Possible Cause:
1. No gas ow.
2. Coupling nut and regulator not fully connected.
3. Obstrucon of gas ow.
4. Disengagement of burner to valve.
5. Incorrect assembly.
6. The distance between the ignion needle and the nozzle
is not suitable.

1. Check to see if propane tank is empty.
2. Turn the coupling nut about one half to three quarters
addional turn unl solid stop. Tighten by hand only –
do not use tools.
3. Clear burner tube.
4. Re-engage burner and valve.
5. Check steps in assembly instrucons.
6. Adjust the distance between ignion needle and nozzle
to 5mm.
SUDDEN DROP IN GAS FLOW OR LOW FLAME
Possible Cause:
1. Out of gas.

1. Check for gas in propane tank.
2. Turn o gas control knob, wait 30 seconds and light oven.
If ames are sll low, turn o gas control knob and propane
tank valve. Disconnect regulator. Reconnect regulator and leak
test. Turn on propane tank valve, wait 30 seconds and then
light oven.

Possible Cause:
1. Grease build up.
2. Excessive fat in meat.
3. Excessive cooking temperature.
4. Excess our on the cooking surface.

1. Clean oven.
2. Trim fats from meat before cooking.
3. Adjust (lower) temperature accordingly.
4. Brush remnant our from cooking surface.
FLAMES ACCIDENTALLY EXTINGUISHED
Possible Cause:
1. High or gusng winds.
2. Low on propane gas.

1. Turn front of oven away from wind.
2. Rell propane tank.
3. Refer to sudden drop in gas ow above.
MAINTENANCE FREQUENCY
According to the frequency of use and habits, before using this
product, you must rst check whether there are cracks in the gas
line, whether the ignion needle and the ignion needle thread
are damaged, and the normal maintenance cycle should
be checked once a week. For replacement parts please contact us
at sales@reoneup.com or 1-877-288-1110.
TROUBLESHOOTING MAINTENANCE