Full Product Manual

25
pinnacolopizzaovens.com
TIPS FOR GAS USE
NOTE: If ow liming device acvates, your
oven may not light. If your oven does not
light, the ames will be low and will not heat
properly. Turn tank valve and burner knob o
and wait 30 seconds. Aer shung o the tank,
very slowly open tank valve and wait 5 seconds
before lighng.
The oven you have purchased may have some or all the feature
listed below. The locaons and appearances of the features
shown here may not match your model.
CONTROL PANEL
A. Baery (for Ignion) Box B. Burner Knob
Any alteraon of the product may be potenally hazardous.
Use only low pressure exible pipes and regulators allowed by
the current regulaon. To replace the pressure regulators and
exible pipes, please refer only to the manufacturer instrucons.
Check hose each me before using the oven for nicks, cracking,
abrasions or cuts. If the hose is found to be damaged in any way,
do not use the oven.
Move the oven door holding the wooden handle.
LIGHTING
Check all gas connecons for gas leaks before starng your oven.
Do not lean over the oven when lighng. Keep your face and
body at least 50 cm/20-in away from the oven door. When
lighng the oven, the oven door must be open.
The burner control knob must be in the OFF posion before
turning on the LPG tank valve.
1. Make sure burner knobs are turned to “OFF”.
2. For gas oven using a propane tank, slowly open the tank valve.
3. Push in and turn the burner knob to IGNITE/HI. The burner
will light immediately. When burner is lit, turn knob to
desired seng.
If the ame does not light, turn the knob to the “OFF
posion. Wait 3 minutes and try again.
Do not keep oven on at the maximum power for more than
20 minutes.
– Do not exceed the limit temperature of 426°C/800°F.
During operaon, never disconnect the gas regulator or
other juncons.
Do not touch external surfaces and the chimney ue during
oven operaon.
Pinnacola_Gas_PizzaOven_Manual_BLK.indd 25Pinnacola_Gas_PizzaOven_Manual_BLK.indd 25 2021-07-02 3:24 PM2021-07-02 3:24 PM