User guide

Torq LE User Guide » Chapter 1

Torq LE User Guide » Chapter 10

Filename

To set the ﬁlename for your recording:

1. Click the Filename button (which looks like “...” when no name is set). A dialog box will open.

2. Select the destination folder for your recording, then give it a name and press enter. The dialog box will close

and your new ﬁlename will be shown on the Filename button.

Note: The sample rate of the recorded ﬁle will match the sample rate currently selected in the Audio tab of

the Preferences.

Setting the Record Level

The Master Volume slider will control the level of your recording. You’ll want to set this slider as high as possible

without constantly triggering the limiter (it’s OK if you trigger the limiter every once in a while). If you set the Master

Volume slider too low, your mix will be recorded quietly and will therefore have less ﬁdelity.

Note: Changes made to the Master Volume slider will be committed to your recording, even while you’re in the

middle of your mix.

Recording

Now that you have set the ﬁlename and recording level, you can begin recording:

1. Click the Record button. It will light up to indicate that recording has commenced. You’ll also see the Record

Time window begin to count the length of the recording.

2. Perform your mixing magic as you normally would.

3. Press the Record button again to stop the recording and save the ﬁle.