Installation Guide
11
CARING FOR YOUR SIGNATURE BATH
• Do not use bubble bath or oil based additives in your Signature Bath.
• The bath should be drained after each use. Each bather should use fresh water.
• Certain cleaning products will permanently damage the bath surface. Read the product label carefully before use to be certain it specically says it’s safe for
acrylic surfaces. Never use scouring pads, harsh or abrasive chemicals, aerosol sprays marketed to clean sinks, baths and tile, disinfectant sprays or ammonia based
cleaning products that are commonly used to clean windows on your Signature Bath.
• Never circulate drain cleaner. It will cause serious damage to your bath.
• Avoid contact with nail polish, nail polish remover, lacquer thinners, gasoline, and certain oils like pine.
• Minor scratches that do not penetrate the surface can be removed with a light sanding with 600 grit wet/dry sandpaper. Bu area with automotive bung
compound followed by automotive paste wax. Do not wax areas where you stand
• Major scratches and gouges require renishing. Contact your dealer for special instruction.
• Do not use bath mats in your Signature Bath.
TROUBLESHOOTING
Error Codes Displayed on the Topside Controls
• E-1: Connection problem between the Variable Speed and Blower Speed Controls and the Topside. Check the connections and reset the GFCI. If problem persists,
call 844-894-6659 for assistance.
• No H20: Will not turn on because the sensor cannot detect water in the bath.
• E-2: Bath shutting down due to overheating. Check the fan in the Variable Speed Control Unit.
• E-3: Connection problem between Port 1 and Blower/Variable Speed Control and Topside. Re-connect securely.
• E-4: Connection problem between Port 2 and Blower/Variable Speed Control and Topside. Re-connect securely.
Troubleshooting Your Bath
DANGER: Risk of severe injury by electric shock or death by electrocution. Disconnect power before servicing.
Pump/Blower does not come on:
Incorrect button pressed. Press correct button.
Breaker at main power supply tripped or malfunctioned. Reset or replace breaker.
GFCI tripped or malfunctioning. Reset or replace.
Power cord not plugged in. Plug cord into GFCI.
In-line heater (if bath is equipped) and pump plugged into same GFCI. Contact electrician to have dedicated GFCI installed for in-line heater.
Plumbing or air line from pump or blower is disconnected. Reconnect.
No water or air ows from jets:
Wrong button pressed. Press correct button.
LARGE WHIRLPOOL JETS ONLY - Jet is rotated to closed position. Rotate jet counter clockwise to open.
Whirlpool jet is not secured in jet housing. Pull jet outward rmly to re-seat jet.
Debris or hair on suction cover. Remove.
Small debris blocking air jet. Removed debris with soft bristle toothbrush.
Return line is higher than the normal waterline. Contact installer it correct elevation of return line.
Low Voltage. Contact electrician to correct wiring.
Pump/Blower Shutting O:
Overheating. Allow to cool. Remove debris from components, increase ventilation around components.
Pump/Blower has automatically timed out. Press pump/blower button to turn back on.
Breaker at power supply or GFCI tripped or malfunctioned. Reset or replace GFCI.
Bath is wired on shared circuit or with an extension cord. Contact electrician to correct wiring.
Air injectors in whirlpool jets don’t work:
Line to pump, controls or manifold not connected, kinked, or damaged. Reconnect. Straighten or replace if necessary.
Lights don’t work:
Wrong button pressed. Press correct button.
Connection problem between lights and topside. Reconnect securely.
Waterfall won’t turn o:
Operating as designed. Cannot stop the ow of water entirely in waterfall designed for continuous ow.
Aromatherapy not working:
Aromatherapy crystals have lost scent. Replace crystal pouch.
Blower not running. Turn blower on.
Rust colored ring in bath:
Sediment in water heater. Flush water heater and clean bath with grease cutting dish soap.
SAVE THESE INSTRUCTIONS
CONTAINS IMPORTANT SAFETY INSTRUCTIONS PERTAINING TO RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS
READ AND FOLLOW ALL INSTRUCTIONS