User Guide

Chapter Finish
11 - 212
Color Correction Editor
1 Load the clip you want to correct in the Color Correction Editor.
2 Define a Reference Source ( page 11-202).
3 Select the Histogram diagnostic display. The histograms for the two clips are both visible
and superimposed on one another (green for the correction clip and blue for the reference
source).
4 Activate the Histogram Adjust function and drag the mouse over the display to match the
histograms as much as possible:
- Drag the left end to adjust Black,
- drag the center to adjust Gamma,
- drag the right end to adjust Gain.
You can do this in all three of the components (R,G and B).
The changes are simultaneously visible in the correction clip.
HueMatch
This function is used to match the correction clip as closely as possible to the Reference Source
and affects saturation and hue.
1 Define a Reference Source ( page 11-202) and call it from the diagnostic display.
2 Define a working rectangle in both the Reference Source and the working image using the
button provided.
Matching is performed on the basis of the working rectangles selected.
If you do not define separate rectangles, the entire image is used.
3 Click the HueMatch button. The change instantly becomes visible in the inlay.