User Guide

Chapter Finish
11 - 114
Effects
w Use the Mirror X Repetition and Mirror Y Repetition functions to mirror wipe area rows or
columns along the center axis. See examples below:
No mirroring (left), mirrored Y repetition (center)
and mirrored X repetition (right)
It is not possible to make changes to the individual areas of a wipe - they can only be
changed collectively. In other words, any change you make to a border, rotation, trans-
parency, etc. is applied to all wipe areas in the same ma1nner.
Step-by-Step: Creating a Transition Wipe
Effect
1 Position the two clips between which you plan to insert a wipe transi-
tion on the Timeline. In the Project window, click
Library Ta b >
Folder Classic Transition FX > Editors in the tree area. Drag the Tran-
sition FX Wipe Editor to the cut between the two clips.
If the transition is not completely gray (i.e. fully or partially red), insufficient leeway was
provided on either the start, end or both sides of the transition. In this case, trim the
mark-in and/or mark-out of the clip(s) until the red disappears (See
“Trimming Objects”
on page 10-71.)