User Guide

Chapter Setup

3 - 19

InTime board Installation

This chapter is designed to help you install the InTime board delivered in the form of a PCI inter-

face board in the PCI slot (as of Ref.No. 2.1) of your computer.

A full-length PCI slot is required for installing the InTime board.

The data transfer from and to InTime takes place via the regular PCI bus, thus making further

connections unnecessary. Each function that has used the processor performance of the CPU

host without InTime is now processed “in time” by one of the six InTime on-board processors.

This allows you to continuously work with Pinnacle Liquid and guarantees fastest results. Thanks

to the software technology referred to as “InTime Processing”, neither image quality, nor flexibil-

ity is impaired.

Hardware Installation

Make sure you are properly grounded when installing a PCI interface board.

Always avoid touching a board’s surfaces without being properly grounded (this applies

also to your clothing).

1 Removing the Housing Cover

First remove any external connections on your computer.

Remove the housing cover from the host PC.

2 Removing the Cover Plates

Remove the cover plate of the required PCI slot by unscrewing the retaining screw. Keep the

screw handy, it will be needed to secure the board once slotted.