User Guide

Chapter Input
8 - 43
Logging and Digitizing (Capture)
w Create Master with inside handle length -
This option generates master clips only, meaning clips with individual clip-in and clip-
out data. You can enter a Handle Length (see below).
Important: You can also trim these master clips to the total available length of their shared
Media File but only by using the Expand Clip(s) function (
page 9-69).
Use Create Master if you want to re-batch the clips later on using Batch Digitize; you will
then obtain one
Media File for each clip.
w Handle length -
The clip-in is set at the point where the scene changes (according to the timestamp) and is
followed by a mark-in. The “distance” between clip-in and mark-in corresponds to the
Handle Length entered. The same distance exists between the mark-out and the subse-
quent clip-out defined by the end of the scene.
For both Subclips and master clips: If you’re using Automatic Scene Detection, be
extremely careful when deleting clips along with the Media File. You need to take into
account that a very large number of clips is attached to the same Media File.