User's Manual

3. Check your dog's neck frequently for any rash or sore spots;
4. Supervise your dog for the first day or two after putting on a bark
stopper;
5. Check the device in real time to prevent excessive pressure. It
can be tolerated when the bark stopper is worn between the dog's neck
The next finger;
6. Scrub the area around the dog's neck and the bark stopper sensor
on a weekly basis.
7. Do not attempt to remove or repair any parts of the product, as
doing so will void the warranty;
8. If your dog shows extreme resistance to wearing a bark stopper or
acts in a dangerous manner, the dog should be removed from the
If the boot is invalid, please stop using the product immediately.
9. We recommend this product for dogs 6 months of age weighing 8 pounds
or more.
10. Bark stopper should not be used continuously for 12 hours within
24 hours.
6. Fault comparison table
Spray bark
stopper not
working
When the traffic light blinks continuously, it indicates
insufficient power and needs to be charged.
If the sprayer still cannot be sprayed, contact your local
distributor
The dog did
not respond
to the spray
Reinforce the bark stopper and ensure that the sensor system
is close to the dog's neck skin
Check and make sure the spray nozzle is pointed at the dog's
nose
Make sure the dog hair doesn't interfere with the spray
Seven, technical parameters
1. Receiver
Input current 0.024 (A)
Input voltage 3.7 (V)
Power 0.09W (W)
Frequency 433.92 (MHz)
2. Remote control
Input current 0.011 (A)
Input voltage 3.0 (V)
Power 0.01W (W)
Frequency 433.92 (MHz)