User Manual

4
4. Attach Strut Tubes (#17) and Linkages (#16) to Caster Beam Assemblies (#8) as shown in Figure 4.
a) Loosen Bolts (#13) and Nuts (#28) so that Strut Tube (#17) can fit between Support Plate (#43) and Caster Beam (#8)
as shown in the Top View and Figure 4.
b) Slide one Hex Bolt (#27) through Caster Beam (#8), one Plastic Washer (#39), Strut Tube (#17), Plastic Washer (#39),
Support Plate (#43) Spacer (#36), Linkage (#16) and Locknut (#28) as shown in Figure 4 and Top View.
c) Repeat on other end of Caster Beam (#8) and on second Caster Beam.
d) Tighten Bolts (#13) and Nuts (#28) (installed in Step 2) securely.
e) Tighten Nuts (#28) on Bolts (#27) securely but DO NOT over tighten, Strut Tube
must Pivot Freely.
Top View
27
39
36
28
17
43
12
16
13
13
8
3. Attach Wood Bottom Board (#15) to Caster Beam Assemblies (#8) as shown in Figure 3. Turn
Caster Beams as shown and attach board with four Carriage Bolts (#31) and four Wing Nuts (#32).
Tighten Thumb Screws securely.
Note: Linkages and Strut
tubes must be turned as
shown or table will not
operate correctly.
8
16
17
16
27
36
28
39
17
Note: Support Plate (#43)
must be on inside of Caster
Rail (#8) as shown.
8
43
15
8
32
32
31
31
Figure 3
Figure 4
28