Instructions / Assembly

PVC Barn Door Assembly and Track Installation G Style 42”
14. Install Floor Guide
The Bottom Door guide (V) keeps the door from swinging
outward away from the wall. To locate the proper installation
position in the oor, slide the door into the closed position and
mark the outside edge of the door on the oor. Now place the
door into the open position and mark the inside edge of the
door on the oor. Make sure your guide location is well marked.
Make sure that whether the door is in the open or closed
position, that the door NEVER leaves the Door guide. This is
the proper location for the Door guide. Set the width of the oor
guide to 1-1/2”. Slide the door out of the way and place the
guide on the oor in between the 2 marks. Pre-drill holes if
necessary for your oor type. Using a drill and the screws
provided, secure the Door guide to the oor. See Figure 15.
2
INCH
2
INCH
1-1/2”
15. Set Door Stops on Track
Make sure the rubber stoppers are facing inward on each side.
Move the door to the closed position and slide the Door stop
to desired location. Using the provided Allen wrench, tighten
the screws in the door stop to secure it into place. Then
carefully glide the door into the fully open position and repeat
the steps for the remaining Door stop. See gure 16.
2
INCH
2
INCH
1-1/2”
Figure 15
Figure 16
(T)