Instructions / Assembly

PVC Barn Door Assembly and Track Installation G Style 42”
Fig. 2A
Fig. 2B
Fig. 2C
Figure 3
Figure 4
Figure 5A
Figure 5B
Figure 6
Figure 6A
Figure 6B
Figure 6C
5. Attach Door Stile
Place side gasket onto window
panel. See Figure 5B.
Take one of the Stiles (A),
making sure the side with the large
holes is facing outward. Insert U
bracket (G) into the Top of the stile
into the outside channel and the
innermost channel. The side of the
U clip with the larger holes should
be facing the outside edge of the
door. The top of the U clip will rest
on the top of the stile once inserted.
See Figure 6.
Place 2 of the 4” screws (Z) into the 2
holes in the outside of the Stile
channel. Make sure they are fully
inserted. Slide a reinforcement clip
(D) into the channel and over the
screw shafts. See Figures 6.
Insert two small screws (Q) into the
oval holes on top of the U bracket and
secure to the top of the stile. Take 2
small screws (Q) and secure into the
oval hole in the outside of U bracket
(G). This will be the outside
channel of the stile.
See Figure 6A & 6B
Place 2 of the 4” screws (Z) into the
2 holes in the outside of the Stile
channel at the bottom of the
window section. Make sure they
are fully inserted. Slide a small
reinforcement clip (F) into the
channel and over the screw shafts.
Line up the 4 screws (Z) inserted
through the Stile with the extrusion holes in the
top rail and the bottom transom rail and tighten
all 4 screws until ush
and secure. See Figure 6C
E4
E4
E4
E4
E6
E1
4. Assemble Top Rail
and Transom Section
Take the Top Rail (C1), making
sure the side with the large
holes is facing to the outside.
Place 2 of the 4” screws (Z)
through the outside channel of
the Top rail until fully inserted.
Place reinforcement clip (F)
onto screw shafts. Take one of
the vertical transom stiles (E2)
and line up the extrusion holes
with the screws. Tighten until
ush and secure. Do not over
tighten. Repeat with the other
transom stile (E2).
See Figure 3.
Snap the top and 2 side
gaskets (E4) into the center
transom channels. Take one of
the window panels (E6),
remove the protective paper,
and slide panel into the center
transom. Place bottom gasket
(E4) onto the center window
panel. See Figure 4.
Attach the Bottom Transom
Rail (E1). Insert 2 of the 4”
screws (Z) into the large holes
in the rail until fully inserted.
Repeat with the other 2 screws
(Z). Line up the extrusion holes
in the transom stiles with the
screws and tighten until ush
and secure. Do not over
tighten. See Figure 5A.
Insert inner side gasket and
then the top and bottom
gaskets (E4) into the next
transom area. Slide a window
panel (E6) (paper removed) into
the gasket channels. Repeat
steps to insert the remaining
window panel. See Figure 5B.
E2
E2
C1
A