Instructions / Assembly

Tools Needed
You will need a Pencil, Phillips head screwdriver, Tape
measure, Drill, Assorted Drill bits (5/16” & 3/8”), 6” phillips
head bit and 1/2” socket ratchet, 4ft Level, Rubber mallet and
Safety glasses.
Parts List
Make sure ALL parts are included before beginning.
NOTE:
It is very important to determine whether you will be installing
a Mounting Board prior to installing the track. If you do need to
install a Mounting Board, it MUST be installed rst.
PVC Barn Door Assembly and Track Installation H Style
Please read ALL instructions before you begin installation.
You MUST determine if you need a Mounting Board prior to doing ANY installation. Due to many overlapping factors
such as the location of wall studs, the weight of a Barn door and the various types of trim used in homes, we
recommend using a Mounting Board in all situations. Track must be installed into Solid Blocking or Head Casing.
Fig. 6
Fig. 7
1-1/2”
4-1/2”
2”
2”
17.75
INCH
17.75
INCH
17.75
INCH
17.75
INCH
4.75
INCH
H +
3 INCH
2. Determine Track
Location
On the same side where you made
your Height mark, measure 4-3/4”
over from the door jamb and draw
a line so the 2 measurements
intersect. This will be the location
of the rst hole in the Track.
See Figure 1.
3. Insert Mounting Hardware
Drill pilot hole. Insert lag bolt through rst track hole, then place
the track spacer through the bolt on back of the track. Install
the lag bolt with ½” socket ratchet. Do not tighten fully because
you will need to swing the track up and complete installation.
Swing track up and using level to ensure track is in the proper
position, mark the remaining holes in the track. Drill remaining
holes and install end bolt and spacer at the end where the door
will be in the closed position. Slide the door stopper (T) for this
end onto the track so it is between the rst and second hole in
the track. Make sure the rubber stoppers are facing inward. Do
not set at this point. Install remaining bolts and spacers. Slide
second door stop (T) onto the other end of the track. Do not set
at this point. Refer to Figures 2A, 2B & 2C.
Figure 1
NOTE NOTE
5 Ea.
5 Ea.
2 Ea.
1 Ea.
8 Ea.
2 Ea.
1 Ea.
2 Ea.
22 Ea.
2 Ea.
2 Ea.
1. Measure for Track Height
In order to determine the proper Height for your Barn Door
Track, add 3” to the height of the door being installed. Locate
and mark this height on the wall (or mounting board) on the
side of the door jamb where the door would be in the closed
position. See Figure 1.
2 Ea.
4 Ea.
1 Ea.
1 Ea.
5 Ea.
5 Ea.
2 Ea.
2 Ea.
2 Ea.
1 Ea.
5 Ea.
1 Ea.
1 Ea.
Fig. 2A
Fig. 2B
Fig. 2C
Figure 2A
Masonry Application
Figure 2B
Mounting Board/Stud Application
Fig. 2A
Fig. 2B
Fig. 2C
2 Ea.
2 Ea.
Fig. 2A
Fig. 2B
Fig. 2C