Instructions / Assembly

PVC Barn Door Assembly and Track Installation G Style 36”
14. Install Floor Guide
The Bottom Door guide keeps the door from swinging outward
away from the wall. To locate the proper installation position in
the oor, slide the door into the closed position and mark the
outside edge of the door on the oor. Now place the door into
the open position and mark the inside edge of the door on the
oor. Make sure your guide location is well marked. Make sure
that whether the door is in the open or closed position, that the
door NEVER leaves the Door guide. This is the proper location
for the Door guide. Set the width of the oor guide to 1 1/2”.
Slide the door out of the way and place it on the oor in between
the 2 marks. Pre-drill holes if necessary for your oor type.
Using a drill and the screws provided, secure the Door guide to
the oor. See Figure 15.
2
INCH
2
INCH
1-1/2”
15. Set Door Stops on Track
Make sure the rubber stoppers are facing inward on each side.
Move the door to the closed position and slide the Door stop
to desired location. Using the provided Allen wrench, tighten
the screws in the door stop to secure it in into place. Then
carefully glide the door into the fully open position and repeat
the steps for the remaining Door stop. See gure 16.
2
INCH
2
INCH
1-1/2”
Figure 15
Figure 16