Instructions / Assembly

ManualsBrandsPinecroft ManualsBarn Doors36 in. x 84 in. Millbrooke Cherry 3-Lite Acrylic Pane Ready to Assemble PVC Vinyl Barn Door w/Sliding Door Hardware Kit

12. Place door onto Track

Position the door over the opening and slightly tilt the bottom

of the door outward away from the wall. Set the rollers securely

onto the track. Once the door is safely mounted and is secure,

turn the 2 safety spacers 180 degrees towards the wall. This

positions them properly under the track. See Figure 13.

PVC Barn Door Assembly and Track Installation G Style 36”

INCH

1-1/2”

Figure 13

13. Install Handle

Measure up 52” from the bottom of the door and mark that

location. Measure in 2 ¾” in from the edge of the stile and mark

this spot. Drill a hole through the stile at the intersection of these

2 marks. Place the handle (P) on the door and insert one of the

handle bolts into the top hole in the handle. Put the washer and

nut onto the backside of the door and tighten the nut. Do not

tighten fully at this point. Using a level to make sure the handle

is plumb, mark the location of the bottom hole in the handle.

Move the handle aside and drill the second hole through the

stile. Put the remaining bolt through the hole in the handle. Put

the washer and nut onto the backside of the door and tighten

the nut. Use the wrench provided to fully tighten the bolts and

secure the handle.

See Figure 14.

INCH

1-1/2”

Figure 14

9. Install Roller Brackets

Line up the holes on the Roller Bracket (O)

with the U bracket (G) and secure with the

2 allen screws. Repeat with the other Roller

bracket (O). See Figure 10.

10. Finishing Strips

Snap the 2 side nishing strips (M) into place. Snap the top and

bottom strips (N) into place. See Figure 11.

Figure 10

Figure 11

11. Install Safety Spacers

Once the Rolling brackets have been secured and the nishing

strips in place, it is important to install the Safety spacers (W).

These spacers help to protect the door from being bumped o of

the track. With the door laying at in a safe and secure position,

place one of the two spacers approximately 2” to the inside of

one of the roller brackets. Place slightly o center towards the

front of the door. Using a drill, secure the spacer with the screw

provided. Repeat steps to install the second spacer inside the

other roller bracket.

See Figure 12.

Figure 12

INCH

1-1/2”