Instructions / Assembly

PVC Barn Door Assembly and Track Installation G Style 36”
4. Assemble Top Rail and Transom Section
Take the Top Rail (C), making
sure the side with the large
holes is facing to the outside.
Place 2 of the 4” screws
through the outside channel of
the Top rail until fully inserted.
Place reinforcement clip onto
screw shafts. Take one of the
vertical transom stiles and line
up the extrusion holes with
the screws. Tighten until ush
and secure. Do not over
tighten. Repeat with the
other transom stile.
See Figure 3.
Snap the top and 2 side
gaskets into the center
transom channels. Take one
of the glass panels, remove
the protective paper, and slide
panel into the center transom.
Place bottom gasket onto the
center glass panel
See Figure 4.
Attach the Bottom
Transom Rail. Insert 2 of the 4”
screws into the large holes in
the rail until fully inserted.
Repeat with the other 2
screws. Line up the extrusion
holes in the transom stiles with
the screws and tighten until
ush and secure. Do not over
tighten. See Figure 5A.
Insert inner side gasket and
then the top and bottom
gaskets into the next transom
area. Slide a glass panel
(paper removed) into the
gasket channels. Repeat steps
to insert the remaining glass
panel. See Figure 5B.
Fig. 2A
Fig. 2B
Fig. 2C
Figure 3
Figure 4
Figure 5A
Figure 5B
Figure 6
Figure 6A
Figure 6B
Figure 6C
5. Attach Door Stile
Take one of the Stiles (A),
making sure the side with the large
holes are facing outward. Insert
U bracket (G) into the Top of the
stile into the outside channel and
the innermost channel. The side
of the U clip with the larger holes
should be facing the outside edge
of the door. The top of the U clip
will rest on the top of the stile once
inserted. See Figure 6.
Place 2 of the 4” screws into the
2 holes in the outside of the Stile
channel. Make sure they are fully
inserted. Slide a reinforcement
clip (D) into the channel and over
the screw shafts. See Figure
6A & 6B.
Insert two smalls crews into the
oval holes on top of the U bracket
and secure to the top of the stile.
Take 2 small screws and secure
into the oval hole in the outside
of U bracket (G). this will be the
outside of the stile. See Figure 6B
Place 2 of the 4” screws into the
2 holes in the outside of the Stile
channel at the bottom of the
window section. Make sure they
are fully inserted. Slide a small
reinforcement clip (F) into the
channel and over the screw shafts.
Line up the 4 screws inserted
through the Stile with the
extrusion holes in the top rail and
the bottom transom rail and
tighten all 4 screws until ush
and secure. See Figure 6C