Instructions / Assembly

Barn Door Track Installation
9. Attaching a Handle
If you install a handle, measure up approximately 38” to 40” from
the bottom of the door (or desired height), mark the location
and then measure in from the edge of the door to where you
would like the handle placement and mark that location. If using
the provided handle, drill a hole at the marked location using a
5/16” drill bit then put one side of the handle, washer and screw
through the hole and then on the back side of the door, place
the other side of handle and washer onto the screw until tight.
If using another type of handle, be sure it corresponds with the
thickness of your Barn door. See Figure #8.
Overview
Fig. 8