Installation Instructions

XL1000Pro
Retrofit Instructions
27. Attach the Output Directional Coupler to the Filter output making sure the directional coupler
sample ports are pointing inward toward the center of the transmitter.
28. Using the marks made at time of disassembly, connect the directional coupler forward and
reflected port cables to the corresponding power meter ports on the rear of the metering panel.
29. Attach the Combiner brace Part Number MF9189 to the back of the transmitter just behind the
filter approximately a third of the way down from the top of the transmitter with the hardware provided.
30. Locate the Driver Directional Coupler, Driver Isolator, and Bandpass Filter removed from the
transmitter during disassembly. In a chain like fashion attach the directional coupler and the isolator
together using one of the type N male to male adapter provided. Make sure they are securely fastened
together.
31. To the directional coupler and isolator combination fasten the Input Bandpass Filter making sure
the adjustment screws of the Bandpass Filter point to the rear of the transmitter. Again make sure there is a
secure connection between the isolator and the Bandpass Filter.
32. Locate the US200 RF splitter provided as part of the retrofit kit. Using the second type N male to
male adapter fasten the input of the US200 to the output of the bandpass filter. At this time you should
have the Splitter Chain assembled, the assembly includes the Driver Directional Coupler, Driver Isolator,
the Driver Bandpass Filter and the US200.
33. Mount the splitter chain on the splitter chain mounting bracket (Part Number MF9174) using
screws provided.
34. From the rear of the transmitter on the left side, attach the splitter chain and mounting bracket to
the transmitter about half way up using the screws provided.
35. Find the appropriately keyed rainbow cable that connected to the metering panel saved during
disassembly. Connect that rainbow cable to the socket labeled P410 on the meter panel. Run the rainbow
cable on the outside of the support bars on the left side of the transmitter securing it with tywraps along the
back left of the transmitter. Plug the other end of the Rainbow cable to the Bias/Fil/Screen assembly socket
labeled P302.
36. Find the second keyed Rainbow cable that connects the Bias/Fil/Screen Assembly to the driver
unit. One end of the cable should have a twistlok socket. Plug in the twistlok to the driver unit. There will
be three wires protruding from the twistlok connector; Brown, Orange, Green. Attach the Brown wire to
the socket labeled TB101-1, attach the Orange wire to socket labeled TB101-2, and attach the Green wire
to socket labeled TB101-3.Plug in the other end of this rainbow cable to the Bias/Fil/Screen Assembly in
socket labeled P301. Route the cable and secure it with tywraps as needed.
37. Find the Bias/Fil/Screen Twistlok cable and connector. Plug in the Bias/Fil/Screen Assembly
twistlok cable into the 110V socket in the junction box. Then insert the twistlok unto the Bias/Fil/Screen
Assembly.
38. Insert the PS130-28 power cable twistlok male plug into the back of the PS130-28 power supply.
39. Plug the DC power cord with the single Andersen Connector to the PS130-28 power supply, then
plug the other ends of the cable into each U600LD.
40. Attach one end of the coax cable with type N connectors removed during disassembly to the driver
assembly. Attach the other end to the directional coupler.